7
BALLAST REPLACEMENT
WARNING
-
Before you replace the ballast, verify the Mini Split HVAC system
is turned off and disconnected from the power source. Failure to disconnect the
power may result in severe electrical shock.
1.
Disconnect the power from the Sanctuairy Mini EM. Remove 6 screws as shown below.
2.
Lift assembly out of housing.
Remove 2 locknuts.
3.
Remove 2-pin power plug from metal
bracket. Slide 4-wire connection out of
bulb assembly connector.
4.
Slide new 4-wire connection
into the bulb assembly
connector and reconnect.
Replace 2-pin power plug into
metal bracket opening.
5.
Replace 2 locknuts and place
new assembly back into the
unit housing.
6.
Reinstall original 6 screws.
Note: The ballast only needs to be replaced if it should fail.
