Aerservice Equipments RECARM, Инструкция по установке и эксплуатации

Страница: 36 / 44

Tel. +39 049 641 679 | commerciale@aercomponents.it | www.aercomponents.it
36
EN
8.3 SURVEILLANCE MODE
To get into this mode, repeatedly press the button MODE (
M
) on remote control, to see the
image below on display.
In this mode the HUMIDITY
button (
H ) is active to select
the desired threshold.
In this mode both humidity and twilight sensors are active, the units will be normally in
stand-by with front panel closed, so that when the humidity level in the room exceeds the set
threshold the units start running in extraction.
Hereinafter explaining how the units run in different situations with related operating
mode.
– In standard humidity conditions the units are in stand-by with the front panel closed and the
sensors active.
– In case of humidity alarm conditions during the day the units run in extraction at the
medium speed.
– In case of humidity alarm conditions during the night the units run in extraction at the
minimum speed.
The units get into humidity alarm when the MASTER unit detects in the room a humidity level
higher than the set threshold among the three values available (40%, 60%, 90%).
Advice for use
Recommended mode when heat recovery is not needed but essential to have a proper ventilation
in the room because of humidity (or CO
2
).
Typical use in holiday homes since heat recovery is not needed and just a proper ventilation is
essential to prevent air stagnation in the premises.
8.4 MANUAL MODE
To get into this mode, repeatedly press the button MODE ( M ) on remote control, to see the
image below on display.
In this mode the IMPELLER
button (
V ) is active to select
the desired speed.