19
5. Use a pen to lightly mark the stabs position in
relation to the fuse on both top and bottom.
6. Mix 30 Minute Epoxy and brush onto the ex-
posed wood in the center of the stab. Make sure
to use epoxy on both top and bottom.
7. Insert stab back in fuse and double check align-
ment. Allow the Epoxy to dry before continuing.
Note:
Clean off excess epoxy using rubbing
alcohol.
Note:
Make certain the stab is pushed all the way
forward
8. Pin each CA hinge using the same method that
was used for the wings.
9. Install the hinges into the stab and elevator and
remove the pins. Use thin CA to glue the hinges
in place.
Note:
Always use a fresh bottle of CA. Old CA will
not cure and can cause failure.
