8
52” Aeroworks Extra 260 Freestyle Assembly Manual
11. Tape the servo lead inside the wing using mask-
ing tape. This will ensure the servo lead does not
fall back into the wing.
1. Gather the items shown below for the installa-
tion of the aileron pushrod.
Required Parts
◊
1 - 2 3/8” Pushrod
◊
2 - 2mm Ball link assemblies
◊
2 - 2x10mm Bolts
◊
2 - 2mm Lock Nuts
Required Tools and Adhesives
◊
1/16” Ball Driver
◊
Small Phillips screw Driver
◊
80 Grit Sandpaper
◊
Masking Tape
◊
1oz Bottle Thick CA Glue
AILERON PUSHROD
ASSEMBLEY
2. Use masking tape to secure the aileron to the
wing as shown. This will ensure that the linkage
is the correct length.
3. Assemble the linkage as shown below.
5. Finished ball link assembly shown below. Re-
peat all previous steps for the remaining wing.
4. Center the servo arm on the servo as shown. Ad-
just the linkage length until the ball link is
aligned with the mounting hole in the control
horn. Mount the ball link to the control horn us-
ing the supplied hardware.
2x10mm
Bolt
Servo Arm
2mm Ball Link
2mm Lock Nut
