6
52” Aeroworks Extra 260 Freestyle Assembly Manual
4. After all 5 CA hinges have been placed in the
wing slide the aileron onto the hinges. Once
again it is very important that the hinge stay
straight.
5. Use a straight edge to make sure that the aileron
sits flush with the wing-tip.
6. Remove the T-pins from each hinge. Deflect the
aileron before gluing to ensure full deflection is
possible. Using a new bottle of thin CA apply 3-
4 drops on each side of the hinge. Be careful not
to over soak the hinges with CA this can cause
failure.
Note:
Always use a fresh bottle of CA. Old CA will
not cure and can cause failure.
1. Gather the items shown below for the installa-
tion of the aileron servo and control horn.
Required Parts
◊
1 - Carbon control horn- Single
Required Parts-Not Included
◊
1 - Aileron Servo w/ mounting hardware
◊
1 - 3/4” Servo Arm
◊
1 - 3” Servo Extension
◊
1 - Aeroworks Safety Clip
Required Tools and Adhesives
◊
Small Phillips screw Driver
◊
80 Grit Sandpaper
◊
1oz Bottle Thick CA Glue
AILERON SERVO
INSTALLATION
7. After the CA has fully cured, check to make
sure the hinges are secure by gently pulling on
the aileron and wing. If you find any loose
hinges, apply more CA to the hinge and recheck.
