52” Aeroworks Extra 260 Freestyle Assembly Manual
7
2. Use 80 Grit Sandpaper to scuff the carbon con-
trol horn where it will be glued to the aileron as
shown below.
3. Test fit aileron control horn before gluing, adjust
fit if necessary.
4. Apply Thick CA inside the aileron control horn
slot.
5. Place aileron control horn into the precut slot.
Wipe away any excess glue that may come out
at this time.
7. Attach the 3” servo extension to the servo wire
and secure using an Aeroworks Safety Clip.
6. With aileron centered in natural position, ensure
the mounting hole of the control horn is centered
on the hinge line as shown.
8. Fasten the pull string from the servo hole to the
male plug of the servo extension.
9. Pull aileron extension through root end of wing.
10. Install servo in servo well with the output arm
toward the leading edge of the wing. Install
servo with mounting hardware provided with the
servo.
L
E
A
D
IN
G
E
D
G
E
