AeroWorks 31% EDGE 540T ARF, Инструкция по сборке

Страница: 4 / 18

STEP A
TIGHTENING AND RE-SHRINKING THE COVERING
Open your kit slowly and take care not to damage any parts of the kit. Remove all parts from their
plastic protective covers for inspection.
Before doing any assembly or installation of any decals it is very important to re-shrink or re-
tighten the already applied Ultracote covering. Due to the shipping process, heat and humidity
changes from different climates, the covering may become lose and wrinkle in the sun. If you
take the time to re-tighten the covering, you will be rewarded with a long lasting beautifully
covered model.
Using you’re covering iron or heat gun with a soft sock, gently apply pressure and rub in the
covering. If any bubbles occur, your iron may be to hot, reduce heat and work slowly. If bubbles
persist, using a small pin, punch holes in the bubble to relieve trapped air and reheat. We do not
recommend using a heat gun on any of the foam surfaces. Too much heat on one area may cause
the foam to melt underneath the wood.
After you have tightened up the covering, it is time to start the assembly of your Edge.
STEP B
FUSELAGE ASSEMBLY
With sharp xacto knife cut covering away from wing and stab tube holes. Cut covering away
from stab and wing anti-rotation holes. Cut covering away from aileron servo wire access slot in
fuse and rudder servo cut outs in the rear of the fuselage. If you are using a lightweight engine
you may select to put your rudder servos in the radio compartment using a pull-pull system. It is
recommended you check your C.G. prior to installing rudder servos.
STEP C
WING ASSEMBLY
1) Locate the pre cut hinge slots in the wing and aileron. The model comes with CA style
hinges pre installed, but not glued into the control surfaces. If you wish to use the CA hinges
3