3)
Locate pre cut hinge locations and glue hinges into fin and rudder. We recommend sealing all
control surfaces with Ultracote.
STEP I
CANOPY/HATCH INSTALLATION
1)
Using scribe lines as reference, cut out canopy.
2)
Trial fit canopy to hatch cover. Do all painting/prep work, dash panels and pilot installation
prior to gluing canopy. (NOTE) We recommend you remove the covering from the cockpit
floor location. We use an automotive trunk spatter spray paint (Grey or White) and paint the
floor location to complete a finished look.
3)
Glue canopy to hatch cover. We use 3M stripping tape to finish out the canopy.
STEP J
COWL INSTALLATION
It is first recommended to install engine per manufactures recommendations.
Engine thrust line is
7/8”
down from top of fuse box sides. 2 to 3 degrees of right thrust and 0
degrees of down thrust. It will be necessary to offset the engine to the left (pilot view)
3/8”
to
compensate for right thrust. This will allow the center of the engine to exit at the center of the
cowl.
1)
Fit cowl to fuse, cutting out where needed to accommodate engine. Remember to fit cowl
over fuse ¾” to 1”.
2)
When fitting cowl to fuse. Use a
3 ½”
spinner to ensure proper alignment with spinner plate
of cowl.
3)
When satisfied with fit drill two 1/8” holes on each side of cowl and through fuse sides.
Approximately ¼” from rear of cowl.
4)
Use 4-40 bolts and blind nuts to attach cowl to fuse.
NOTE: We recommend using metal/rubber washer to secure bolt.
Metal
washer
with
rubber
backing
10
Содержание 31% EDGE 540T ARF
Страница 1: ...AEROWORKS 31 EDGE 540T ARF ASSEMBLY MANUAL...
