AeroWorks 31% EDGE 540T ARF, Инструкция по сборке

Страница: 10 / 18

STEP F
LANDING GEAR
1) Drill or tap axle hole in gear to fit your axle. We recommend 3/16” dia. Axle.
2) Install axles using thread lock or lock nut.
3)
Draw a centerline, front to back, down both aluminum landing gear and ply mounting plate.
4)
Align center marks.
The gear provided will
use four bolts
5) With gear centered on center line and 2 1/2” back from Former F1, drill four equally spaced
holes through gear and mounting plate,
two front and two back , to accommodate
10-32 bolts.
Use 10/32 bolts and blind nuts to attach gear to block. Special note : Use thread lock on all
Gear bolts.
STEP H
FIN AND RUDDER ASSEMBLY
1) Locate the hardwood block pre installed in the rudder for the control horn. Drill and tap for
8-32 all thread. Install all thread into rudder and secure with flat washer and nut on each side.
You should have approximately 1” of bolt on each side of the rudder for the mounting of the
control horns.
Use thread lock to secure.
Pictures are
of different
model but
procedure is
the same
2) Trail fit fin to fuse. Remove fin. Apply epoxy to all surfaces to be glued. Slide fin into the
fuse. Use tape to hold in place while assembly dries. (NOTE) Remove covering from all
glue areas and make sure the fin is glued to the rear of the fuse.
Remove
covering
from glue
areas
Epoxy fin
to fuselage
9