Aerotech LaserTurn 1 Series, Руководство по оборудованию

Страница: 19 / 58

LaserTurn
®
1 Hardware Manual Installation
2.6. Attaching the Payload to the Stage
To prevent damage to the stage or parts, test the operation of the stage before any material is held in the
collet or gripper. Proceed with the electrical installation and test the motion control system. Document all
results for future reference. For information on electrical connections, refer to the documentation of the
motion control system and
Chapter 3 .
Linear
The LaserTurn
®
1 has optional front and rear tooling platforms. The surfaces of these platforms are precision
surfaces that have been machined flat.
Rotary
To operate the collet, clean compressed air or nitrogen must be supplied to the stage (refer to Section 2.4. ).
The one-touch air inlet fitting accepts 4 mm OD plastic air line. Simply push the air line into the fitting and
supply air to the stage. The CGF pneumatics kit option contains the required air supply components, such as
valves, filters, and airlines.
Once air is supplied, material of the appropriate size can be placed in the collet. All collets supplied by
Aerotech are clearly labeled with their clamping size range and collet style. Be sure to use only the correct
size material in the collet. If an incorrect material size is clamped, the accuracy of the collet could be
compromised. Refer to
Section 2.8.1. for collet installation.
W A R N I N G : The size of material should match the collet size and be inserted into the collet
at least 2/3 the length of the collet bore. Material that is larger or smaller than the collet or not
inserted far enough into the collet will affect system performance, particularly material runout. In
worst-case scenarios, the collet could be damaged and have to be replaced.
www.aerotech.com Chapter 2 19