Aerotech ABL1500WB-B Series, Руководство по оборудованию

Страница: 22 / 50

Mechanical Specifications and Installation ABL1500WB-B Hardware Manual
2.4. Attaching the Payload to the Stage
To prevent damage to the payload or stage, test the operation of the stage before the payload is attached.
Aerotech recommends that customers use a representative payload during start-up to prevent accidental
damage to the stage and the payload. Proceed with the electrical installation and test the motion control
system in accordance with the system documentation. Document all results for future reference. For
information on electrical installation refer to
Chapter 3 and the documentation delivered with the stage.
N O T E : If your ABL1500WB-B was purchased with Aerotech controls, it might have been tuned with a
representative payload based on the information provided at the time of order. If the ABL1500WB-B is
started up without a payload, the servo gains provided by Aerotech with the shipment may not be
appropriate and servo instability can occur. Refer to the controller help file for tuning assistance.
The payload must be flat, rigid, and comparable to the stage in quality to maintain optimum performance.
N O T E : For valid system performance, the mounting interface should be flat within 2.5 µm.
Load Capability
Applied loads should be symmetrically distributed whenever possible (i.e., the payload should be centered
on the stage table and the entire stage should be centered on the support structure).
If cantilevered loads are applied, refer to Figure 2-6 to find the maximum allowable load.
Figure 2-6: Cantilevered Load Capability
22 Chapter 2 www.aerotech.com