Aerotech ABL1500WB-B Series, Руководство по оборудованию

Страница: 15 / 50

ABL1500WB-B Hardware Manual Mechanical Specifications and Installation
Chapter 2: Installation
W A R N I N G : ABL1500WB-B installation must be in accordance to instructions provided by
this manual and any accompanying documentation. Failure to follow these instructions could
result in injury or damage to the equipment.
2.1. Unpacking and Handling the Stage
D A N G E R / H E A V Y : Do not attempt to manually lift the ABL1500WB-B. Refer to for stage
mass specifications.
l
Lift only with the supplied lifting hardware and lifting straps.
l
Use the eyebolts in conjunction with lifting straps.
l
The lifting straps should be configured to pull on the eyebolts in the vertical direction only.
l
Do not use the tabletop or cable as lifting points.
W A R N I N G : It is the customer's responsibility to safely and carefully lift the stage.
l
Make sure that all moving parts are secure before moving the ABL1500WB-B. Unsecured
moving parts may shift and cause bodily injury.
l
Improper handling could adversely affect the performance of the ABL1500WB-B. Use care
when moving the ABL1500WB-B.
N O T E : If any damage has occurred during shipping, report it immediately.
Carefully remove the ABL1500WB-B from its protective shipping container. Use the lifting equipment to
gently set the ABL1500WB-B on a smooth, flat, and clean surface.
Before operating the ABL1500WB-B, it is important to let it stabilize at room temperature for at least 12
hours. Allowing it to stabilize to room temperature will ensure that all of the alignments, preloads, and
tolerances are the same as they were when tested at Aerotech. Use compressed nitrogen or clean, dry, oil-
less air to remove any dust or debris that has collected during shipping.
Lifting Hardware
ABL1500WB-B stages come equipped with lifting bars and eyebolts attached to the stage as shown in
Figure 2-1 . The bellows are detached from the end-plates to allow access to these features. For multi-axis
assemblies, always lift the system by the lower axis. Lifting by the upper axis may disturb precision
alignments on the system.
Each ABL1500WB-B has a label listing the system part number and serial number. These numbers contain
information necessary for maintaining or updating system hardware and software. Locate this label and
record the information for later reference.
Shipping Clamps
Red, anodized aluminum shipping brackets have been installed to prevent unwanted motion and potential
damage from occurring during shipment. The brackets must be removed before the ABL1500WB-B can be
operated. Retain the brackets and hardware for future use.
W A R N I N G : Do not attempt to move the carriage (or table top) of the ABL1500WB-B until the
lifting and shipping brackets have been removed. Moving the carriage with the lifting and
shipping brackets installed can cause permanent damage to the ABL1500WB-B.
www.aerotech.com Chapter 2 15