8
7. Spread the wings almost all the way so that the glider is resting on the wing tips and on the keel tube.
L
et the keel tube end rest on the ground. C
heck all cables for any twisted thimbles or tangled cables.
8. Attach the bottom front wires to the hook on the bottom nose plate.
9. Attach the struts to the control frame corner fittings using clevis pins and safety rings. Each strut is
marked as left and right. Attach the struts to the cross bar fittings using clevis pins and safety rings.
10. Holding the pullback wire handle with one hand lift the keel tube end up. Place the end of the keel
tube on the keel tube stinger.
11. Remove the battens from the batten bag and check each batten for symmetry against the
corresponding batten from the other wing. Align the battens at their front tips, and at about the 60% of the
chord point. There should not be any deviation of more than 3 mm (1/8’’) from one batten to the other
along the full length of the battens.
Содержание COMBAT 12T
Страница 2: ...2...
