Aeros COMBAT-09, Руководство по эксплуатации для владельца

Страница: 9 / 48

To open or close the batten tip lever press firmly on the undersurface of the tip lever to disengage or engage it
(Fig.10).
Fig. 10 a Fig. 10 b
Fig. 11
Insert the battens carefully so as to minimize stress
and wear on the sail (
Fig.11).
Never insert or remove top surface battens with the
cross-bar tensioned (except for up to the last four on each
side) and never insert or remove battens with heavy wind
pressure on the top of the sail or in any condition which
causes the battens to slide with great resistance in the
pockets.
Fig. 12
9. Spread the wings all the way and check all cables for
any twisted thimbles or tangled cables. At the rear of the
keel find the shackle of the sweep wire. Pull the shackle
out the rear end of the keel pocket, and check that the
sweep wire is not wrapped around the keel. Attach the
shackle of the sweep wire to the hook on the keel tube
(
Fig.12).
An in-flight disengagement of this attachment
will cause a complete loss of structural support of
the glider and a total loss of control. Never attach
the pull handle of the shackle to the hook, even
temporarily.
10. Remove the protection bags from the wing tips and install the last four outboard top surface battens.
8