R-28
19
Fit canopy to fuselage and tack-glue with only a few drops of white glue. This will allow the canopy to be removed with
the help of a modeller´s knife later on.
Carefully sand top of canopy and make sure triangular stock is flush with fuselage sides. Then glue R-28 in place and
secure with tape.
17
Glue R-17 in place at rear end of fuselage. The elevator
pushrod housing should move freely in the notch in R-17.
R-17 is temporarily used to support the fuselage sides at the
rear and part of it will be cut off when the tailunit is installed.
R-17
Sand front of fuselage flush with R-10/R-11 and glue R-36 in
place.
Note:
Take care to match motor mountig holes of R-36 with
holes in R10/R-11.
20
R-36
Glue R-4 in place and secure with tape at former positions. In between formers use
clamps to secure R-4.
18
R-4
