Glue battery tray to former R-5, insert tabs on R-12 into notches in fuselage sides and secure
with tape or clamps until glue has dried.
Select R-10 or R-11 for motor installation. The difference between both formers is the
orientation of the mounting holes. Select the former which suits your motor best and make sure
there is enough room for the motor cables when you install the motor. Glue R-10 or R-11 in
place and secure with tape until glue has completely dried.
Note:
Left fuselage side R-2 has been omitted in this view for clarity.
R-21
R-22
R-12
R-14
6
Glue wing supports R-30 and R-31 (3 mm balsa) to the inside of fuselage.
Glue reinforcements for wing dowel holes R-34 und R-35 (1 mm plywood)
to the inside of the fuselage as well.
R-34
R-30
R-35
With a modeller´s knife or a razor saw cut out the canopy side panels.
Then glue parts R-18 and R-19 in place.
7
8
Glue former R-12 to battery tray R-14. Make sure
R-12 is perpendicular to R-14. Let dry.
R-18
R-19
R-5
R-10/R-11
R-31
5
R-24
R-23
R-20
Glue reinforcements R-23 and R-24 in place on canopy
frame R-20. Make sure that reinforcements are flush with
outer contour of frame.
9
Sand underside of canopy frames R-21 und R-22 to fit
installation and glue frames in place.
10
R-12
