25
25
25
26
26
27
27
23
23
24
24
Fit stringers 24 to formers along the outside of parts 23 and glue in place. Make sure that stringers are fully seated in notches of formers.
Now is a good time to treat the inside of the hull with wood filler or diluted epoxy resin to protect the wood against moisture.
12
Glue reinforcement 26 and steel plate 27 to frame 25.
Then glue frame 25 to front of parts 23.
Note:
Reinforcement and steel plate face down!
13
28
28
28
23
19
20.1
20.1
20.1
30
23
29
30
Flush witht the upper edge glue mahogany panels 28 to the outside of parts 23. Make sure there is a gap of approximately 1.5
to 2 mm between stringer 19 and the lower edge of part 28. Remove any residual glue from the gap.
Insert deck parts 29 + 30 into the gap beneath the side panels 28 and secure temporarily with tape or clamps. Apply tape
along the contact surfaces of parts 28, 29 and 30 to protect the surface against glue. Then glue decks in place and and secure
until the glue has dried completely.
Note:
Glue two pieces 20.1 to the inside of each sponson, if you want
to secure the steel fin/airtrap to the sponsons with srews later on.
14
15