70
73
74
107
107
71
72
71
Glue in place mahogany side panels 71. Mark positions of control linkage slots on part 72 and use a small file or
razor saw to cut slots.
Drill holes for motor cables into part 72, then glue part 72 in place.
34
35
Adjust the hight of servo tray 73 and mounting brackets 74 to fit the servo
you want to install, then glue parts into hull.
Install connectors 107 to servo arm. Glue in parts 69 + 70. Drill two 3 mm
holes in part 70 and install outbord motor with screws 91 and stop nuts 92.
98
98
90
89
89
99
100
89.1
89.1
109
106
95
96
97
99
From the outside insert pulley 96 with shaft 95 into cutout in side panel, then glue in place cover 97 over pulley.
Route wire 99
over pulleys 96 and through hull.
96
36
37
Drill two 2 mm holes for bracket 98 and install bracket with screws 90, washer 89.1 and
stop nuts 89.
Install turn buckle 109 to bracket 98. Route wire through block 106, sleeve 100, through
ring of turnbuckle 109 and again through sleeve 100.
Use small snub-nosed pliers to squeesze the sleeve at two positions and secure the wire.