8
12. Install the steel tiller horn just behind the hinge line on the bottom of the rudder using the two small
wood screws
(figure 25, 26, and 27).
Set aside your two tiller springs, we will install those later after the rudder is mounted.
Chapter 4
Canopy Hatch and Cowling
Place an
to ensure task completion:
Gather the following for canopy and hatch installation:
Canopy
Fuselage and Access Hatch
12 small wood screws
Two 4/40 bolts with spring and flat washers
Cowling
3
Four 6/32 x /
bolts with spring and flat washers
4
Not Provided:
1
/
2
inch low tack masking tape
Drill and small drill bit for wood screws
Canopy glue(iptional)
1. Install the hatch on the fuselage using four 4/40 bolts with spring
and flat washers provided
(figure28).
2. Trial fit the canopy to the fuselage access hatch to determine screw
locations.
3. Mark evenly spaced locations for the screws using at least six per
side. Also mark three evenly space locations around the front of the
canopy. Doublc chcck to cnsurc all thc marked scrcw locations will
go into the center of the hatch rail
(figure29).
4. Remove canopy from the access hatch and drill the marked
locations for the canopy screws.
