AERMEC WLRC10, Руководство пользователя

Страница: 8 / 20

8
SETTING THE FAN SPEED
If the unit is on (and the automatic or dehumidification modes
are not selected), pressing the button allows the selec-
tion of the fan speed. Pressing the button allows changing
the fan speeds as shown in the icons below, in the following
sequence:
Setting the fan speed
AUTO Minimum Averaged Maximum
NOTE:
Besides the three speeds (AUTO automatically selects the
best speed based on the room temperature), there is a
function called TURBO (explained earlier) which adds a
further speed above the maximum speed.
SETTING THE MOTORISED DISCHARGE FIN (SWING)
If the unit is on, while pressing the button it activates the
swing of the motorized supply air fin. The fin allows to change
the air flow in the room depending on the set position; The
logic where this function is managed:
When the unit is on, while pressing the button
it’s possible
to set one by one the following steps:
Motorised discharge
fin setting
Fluctuation
continues(*)
Fixed
(Step 1)
Fixed
(Step 2)
Fixed
(Step 3)
Fixed
(Step 4)
Fixed
(Step 5)
(*) Are present in spite of different icons for continuous oscilla-
tion, all 4 trigger the same mode: oscillazzione continues from
the lowest point to the highest point
Fluctuation
continues (*)
Fluctuation
continues (*)
Fluctuation
continues(*)
, ,
=
NOTE:
In order to block in a precise position the fin during the swing
mode, keep the button pressed for at least 2 seconds,
and release it once the fin reaches the desired position.