24
NRL 0280-0750 60Hz
EN
1
2
4
4
6
7
7
8
3
6
9
10
10
12
11
VERSIONE “POMPE+ACCUMULO”
13
FORNITO DI SERIE:
1. scambiatore
2. filtro acqua
3. flussostato
4. sonde temperatura acqua (IN-OUT)
5. rubinetto di scarico
6. valvola di sfiato
8. pompa
9. accumulo
10. vaso d’espansione
11. vavola di sicurezza (bar...?)
12. scarico accumulo
NON FORNITO / CONSIGLIATO:
6. valvola di sfiato
7. giunti antivibranti
10. vaso d’espansione
13. gruppo di caricamento
14. val
5
14
14
15
HYDRAULIC COMPONENT
NRL
HYDRAULIC COMPONENT
RECOMMENDED EXTERNAL UNIT
11.3.
INTERNAL AND EXTERNAL HYDRAULIC CIRCUIT - NRL PUMP VERSION AND STORAGE TANK
STANDARD COMPONENT
1.
Exchanger plate
2.
Water filter (fitted)
3.
Flow switch
(fitted)
4.
Water temperature probes (IN-OUT)
5.
Ball stop drain
6.
Air Vent
8.
Pump
9.
Tank
10.
Expansion tank
11.
Safety valve
12.
Ball stop Tank
14.
Ball Stop
RECOMMENDED COMPONENTS NOT SUPPLIED
(CHARGED TO THE INSTALLER)
6.
Air Vent
7.
Anti-vibration couplings
10.
Expansion tank
13.
Charging unit
14.
Ball Stop
15.
Manometer
ATTENTION
The choice and the installation of
components external to the NRL
up to the installer, who must ope-
rate according to the rules of good
technical design and in compliance
with the regulations in force in the
country of destination.
ATTENTION
The hydraulic pipes connecting to
the machine must be properly si-
zed to the actual flow of water re-
quired by the system in operation.
The water flow to the exchanger
must always be constant.
ATTENTION
Carefully wash the plant, before
connecting the unit. This allows
cleaning to remove any residue
such as weld spatter, slag, rust or
other impurities from the pipes.
These substances may otherwise
accumulate in and cause a machi-
ne malfunction. The connecting
pipes should be supported so as
not to weigh, with their weight on
the unit.
THE DRAWINGS ARE ONLY EXAM-
PLES OF THE HYDRAULIC CIRCUIT.
System: Chiller with plate heat exchanger
PH
7.5-9
Electric conductivity
10-500μS/cm
Total hardness
4.5-8.5°dH
Temperature
< 65°C
Oxygen content
< 0.1 ppm
Max. glycol amount
50%
Phosphates (PO4)
< 2ppm
Manganese (Mn)
< 0.05 ppm
Iron (Fe)
< 0.3 ppm
Alkalinity (HCO3)
70 - 300 ppm
Chloride ions (Cl-)
< 50 ppm
Sulphate ions (SO4)
< 50 ppm
Sulphide ion (S)
none
Ammonium ions (NH4)
none
Silica (SiO2)
< 30ppm
Содержание NRL0280E
Страница 2: ......
