24
OPERATION OF THE AIR CONDITIONER
REGULATION OF TIMER
TO TIME THE START
WHEN THE AIR CONDITIONER IS OFF
SET THE OPERATION VALUES
– operation mode (e.g. cooling),
– temperature (e.g. 25 °C) and fan speed.
❶
PRESS THE TIMER KEY
(
),
The symbol
is shown on display.
❷
PRESS
or
to set the required time.
(Setting with 10 minute steps).
❸
PRESS SET/C
to confirm the setting.
The yellow lamp in the unit will light up.
✭
The air conditioner will start operating before the set time to let the room reach the temperatu-
re setting.
✭
The advance is calculated by microprocessor according to the room temperature and
temperature setting.
PRESS SET/C
to shut off the timer.
The display will return to show the actual time.
The
symbol disappears and the yellow led of the indoor unit goes off.
To check whether the timer is ON check the yellow led of the indoor unit.
–
+
AM
FULL POWER
MODE
SWING
FAN
SET/C
–
+
1
2
3
2
AM
FULL POWER
MODE
SWING
FAN
SET/C
–
+
2
3
2
1
REGULATION OF TIMER
TO TIME THE STOP
WHEN THE AIR CONDITIONER IS ON
❶
PRESS THE TIMER KEY
(
),
The symbol
is shown on display.
❷
PRESS
or
to set the required time.
(Setting with 10 minute steps).
❸
PRESS SET/C
to confirm the setting.
The yellow lamp in the unit will light up.
✭
The air conditioner is cut off at the pre-set time (eg. in 8 hours time).
✭
The temperature is changed one hour after the timer is started:
– it increases by 1 °C if the air conditioner is working on COOLING mode or in
DEHUMIDIFICATION
– it goes down by 3 °C if the unit is working on HEATING mode.
PRESS THE SET/C KEY
to shut off the timer.
The display goes back to showing the actual time.
The
symbol disappears and the yellow led of the indoor unit goes off.
To check whether the timer is ON check the yellow led of the indoor unit.
–
+
◆
If the setting of the timer has to be changed, repeat operations starting from the beginning.
◆
If the temperature or operating mode setting have to be changed, simply press the relevant key without changing the timer settings.
PM
AM
COMBINED USE OF TIMERS
PROGRAMMING START AND STOP
❶
Set the stop with the timer, e.g. for 23:00 (11:00 pm) during operation.
❷
Set the start with the timer, e.g. for 07:00 am.
The arrows indicate which of the two timers will be started first.
Different temperatures or settings cannot be programmed between start and stop. Each of the
two timers can be programmed before the other.
