Aerco INNOVATION INN1060, Руководство пользователя

Страница: 168 / 200

GF
-
5050
TAG-0043_0C
Venting and Combustion Air Guide
Page 168 of 200
AERCO International, Inc. • 100 Oritani Dr. • Blauvelt, NY 10913 • Ph.: 800-526-0288
07/21/11
3.3 INSTALLATION PROCEDURE FOR VERTICAL VENTING
DO NOT INSULATE OR OTHER WISE WRAP VENT PIPE OR FITTINGS.
FOLLOW THE VENT PIPE MANUFACTURERS INSTALLATION
INSTRUCTIONS FOR VERTICAL VENTING.
The Vent Termination Must Be Located As Follows:
a. Combustion air inlet must be 3 ft below any vent outlet, within 10 ft. See Figure 9.
b. Vertical terminations shall extend at least 3 ft. (0.9 m) above the highest point where it
passes through a roof of a building and at least 2 ft. (0.6 m) higher than any portion of the
building within a horizontal distance of 10 ft. (3 m). Terminations that extend more than 2 ft
above the roof must be laterally supported.
c. Combustion air inlet must also face away from the vent outlet see Figure 9.
d. Use vent pipe manufacturers vent cap, fire stop, support collar, roof flushing, and storm
collar.
LESS THAN 10 FT
(305 CM)
MORE THAN 10 FT
(305 CM)
10 FT
(305 CM)
NOTE:
NO HEIGHT ABOVE RIDGE REQUIRED FOR
VENT TERMINATION WHEN DISTANCE FROM
RIDGE IS MORE THAN 10 FT (305 CM).
IF DISTANCE FROM RIDGE IS LESS THAN 10 FT
(305 CM), TERMINATION MUST BE A MIN. OF 2
FT ABOVE RIDGE.
RIDGE
3 FT (91 CM)
MINIMUM
3 FT (91 CM)
MINIMUM
2 FT (61 CM) MIN.
Figure 9. Acceptable Combustion Air Inlet & Vent Outlet Configuration