14
3.2.4 MANUAL CONTROL
Press both and for about 5 seconds.
Four lines are shown on the display and then the % of the 0-10V regulation.
Release and (the led of the two buttons flash).
Press to increase the regulation value.
Press to decrease the regulation value.
The regulation % remains fixed at the desired point.
BACK TO THE AUTOMATIC MODE
Press both and for about 5 seconds.
Four lines are shown on the display and then the wind speed is displayed (the leds switch off).
3.2.3 READING OF VENTILATION %
Press or : the ventilation % is displayed.
Release or : the wind speed is shown on the display.
3.2.5 SETTING OF THE CONSTANT DATA
Press both and for about 5 seconds.
Four lines are shown on the display and then the message
CONF.
is displayed.
Press to scroll the setting menu.
Parameters:
P.r.o.b.
Cor.t
. = temperature probe correction
SCAL
= °C/°F Celsius or Fahrenheit degree
Air
SP.Lo
= % of minimum speed
SP.Hi
= % of the maximum speed
P.b.
= proportional band of regulation
A.v.Lo.
= minimum anemometer alarm
A.v.Hi.
= maximum anemometer alarm
D.SE.r
= anemometer alarm relays hysteresis
D.SE.t
= on/off temperature block hysteresis
t.Int.
= 0-10V integration time
ImP.
= number of pulses per revolution
Circ.
= blade circumference
Unit
= unit of measure 0=m/s 1=mph 2=km/h
Star
= % minimum starting speed
Press twice the button : the temperature block setting (
SET.C = 10.0°
) is displayed.
Connect the temperature probe (mandatory): when the detected temperature goes below the set level, the 0-10V signal is inhibited.
Touch or to increase or decrease.
3.3 TEMPERATURE BLOCK
3.5 SYSTEM RESET
Disconnect the controller from the main power supply.
Connect the controller to the main power supply and keep pressed until the word BOOT is displayed.
Release and wait for the reset.
Attention: Any setting will return to the default
+
+
-
Press : the diagram is displayed followed by the maximum registered wind value. Keeping pressed for more than 3 seconds, the word CLEA. is
shown and the memory is cleared.
Press : the diagram is displayed followed by the minimum registered wind value. Keeping pressed for more than 3 seconds, the word CLEA. is
shown and the memory is cleared.
3.4 MEMORY OF THE REGISTERED WIND (the values are retained even with the controller switched off)
-
+
+
+
-
-
+
