AEQ
FORUM
LITE
Ultra-compact digital audio mixer
14
The
upper
key is associated with
ON
function and has a red light built in and the
lower
key is
associated with
OFF
function and has a yellow light. The operation is exclusive, both keys can
not be turned on simultaneously. This is the
NORMAL
working mode.
As indicated below in section 3.3, when a new configuration memory or snapshot is loaded, the
audio of the activated channel or channels (ON AIR) will not be interrupted (and the associated
routing will remain) provided that in the new memory those channels are placed in the same
fader positions. When the option "
Snapshot: Blink when the signal has not been loaded
" is
also activated in the configuration (see section 4.2.8 of this manual), the
upper activation key
of those activated channels will start blinking to indicate that they keep the previous
configuration.
There are 3 additional working modes for the channel activation keys that can be activated in
the corresponding configuration memory or snapshot. In these modes, the
upper
key is
associated with
ON/OFF
function and the
lower
key works as follows:
•
ORDERS:
when you press and keep pressed the
key you send the orders microphone
to the output channel associated with the input present at the channel (Talkback
functionality).
•
A/B:
if you press the key for more than 500 ms, when you release it a fast change of
the input assigned to the channel is accomplished (it is shown in the channel display).
•
GPO:
when you press and keep pressed the key you activate the physical or virtual
GPO output associated with the input present at the channel (the GPO is deactivated
when you release the key).
For more information about these modes, see section 4.3.5 of this manual.
These keys can be activated remotely by GPI. To configure remote activation, see section
4.2.3.1 of this manual.
2.1.2. Control and monitoring section.
The control and monitoring section (C&M) of the control surface is usually located to the right.
This section enables the overall management of the signals on the system, including routing
and control processes, as well as monitoring of the signals used in developing the final
program, by means of the VU-Meters, and CUE control.
ON AIR INDICATOR
CHANNEL ON
CHANNEL OFF