Installation and Operation Manual for
the AENO TB2 electric blender
©
ASBISc Enterprises PLC. All rights reserved
Document version: 1.0.1, aeno.com
Page
7
of
44
•
people with disabilities who are physically able to operate and maintain
the device in accordance with this user manual.
3.
Place the device on a dry and clean horizontal surface, making sure there is no
chance of it toppling over. Never tilt the device while it is operating.
4.
Do not install the device near open flames, hot surfaces, or heating appliances.
5.
Do not touch the jug of the device during operation due to the possible heating
of its surface.
6.
Do not open the large lid of the jug during operation.
7.
Observe the minimum and maximum loading levels of the jug of the device.
8.
Never use a device to chop sugar cubes or tough, fibrous plant foods (e.g.
asparagus, beans, parsley). Fiber ingress and twisting on the axle of the knife
mechanism can lead to overheating of the motor and serious damage to the
device. Shred the fibrous stems of the plants before cooking.
9.
Keep a minimum distance from other objects when operating the device (at
least 15 cm).
10.
Do not store the jug in the refrigerator, as the resulting condensation can short-
circuit the electrical contacts.
11.
Do not touch the blades of the device with your hands to avoid cuts. Use the
supplied brush to clean the blades.
12.
Do not use the blender in areas with extreme temperature fluctuations, in humid
atmospheres, or where splashes of water, drips or condensation might get on
the electrical contacts of the blender base, to avoid fire and/or electric shock.
13.
Before connecting the device to the power source, check that the rated voltage
indicated in the technical documentation corresponds to the electrical voltage
of the outlet.
14.
Before turning on the device, make sure that the jug is properly installed and the
lids are closed.
15.
Plug the power cord into and unplug it from the outlet only with dry hands.
16.
Place the power cord so that it cannot be accidentally stepped on or snagged.
17.
Do not place the power cord on anything with a sharp edge and do not place
anything on top of the cord.
18.
Make sure that the power cord does not hang over the edge of furniture or touch
surfaces that can damage the insulation.
19.
Do not wrap the power cord around the device.
20.
If the power cord is damaged, first unplug the power outlet, then unplug the
device. The power cord should only be replaced by a service technician.
21.
Always unplug the power cord after using or cleaning the device.
22.
Use only attachments, accessories, materials or replacement parts
recommended or supplied by ASBISc for this model.
Содержание ATB0002
Страница 2: ......
