AEMC PowerPad 8436, Быстрый старт

Страница: 10 / 16

10
SD-Card
SD-Cards are supported. To access the SD-Card:
1. Ensure the instrument is disconnected and OFF.
2. Use a screwdriver to unscrew the 6 screws of the battery compartment cover.
3. Remove the cover and withdraw the battery from its compartment without
disconnecting it.
4. Press on the SD-Card to release it, then press on the protecting tab to withdraw it
from its slot.
5. Ensure the SD-Card contacts are on the left side, and the locator down.
6. Slide the card into its slot until it snaps into place. The protecting tab is at the top
of the card.
7. Place the battery back in its compartment and screw the cover back on.
Getting Started
NOTE: Ensure the PowerPad
®
is fully charged before use.
Connecting:
1.
Press the button to turn the instrument ON.
2. Configure the instrument to obtain the required results and type of network.
3. Connect the current leads and sensors to the PowerPad
®
.
4. Connect the ground and/or neutral lead to the network ground and/or neutral
(when distributed), as well as the corresponding current sensor.
5. Connect the L1 phase lead to the network L1 phase, as well as the corresponding
current sensor.
6. Repeat the procedure for phases L2, L3 and N.
Disconnecting:
1. Proceed in the reverse order to connecting, always finishing by disconnecting the
ground and/or neutral (when distributed).
2.
Disconnect the leads and press the button to turn the instrument OFF.
3. Recharge the battery, if necessary.