2
Warning !
Please refer to the User’s Manual before using the
instrument.
In this User’s Manual, the instructions preceded by the above
symbol, should they not be carried out as shown, can result in a
physical accident or damage the instrument and the installations.
This device is protected by a double insulation or by a reinforced
insulation. No linking is required from the protection earth terminal
to ensure the electrical security.
Thank you for purchasing a
C.A 5230 RMS Multimeter
. To get the
best service from this instrument :
read
this user manual carefully,
respect
the safety precautions detailed.
SAFETY PRECAUTIONS
Respect the value and the type of fuses or there is risk of
deterioration of the instrument and invalidation of the warranty.
- Fuse 0.5A HBC (500V min - 10kA - 6.3 x 32mm)
- Fuse 12A HBC (600V min - 300kA - 10.3 x 38mm)
Never use on voltage to earth circuits above 600V, with a voltage
surge category of over III, that is to say, fixed industrial and
domestic installations (ref. IEC 664-1).
To be used indoors in environments with a maximum pollution
degree of 2 (ref. IEC 664-1), a temperature between 0 and 50°C
and relative humidity below 70%.
Use accessories which conform to safety standards
(IEC 1010-2-031), with a minimum voltage of 600V and a voltage
surge of category III.
Never open the multimeter case before disconnecting from any
electrical source.
Never connect up to a circuit to be measured if the multimeter
case is not closed correctly.
Before any measurements are taken, ensure the leads and switch
are in the correct positions.
Never measure resistances on a circuit with the power switched
on.
