AEG SRP 4342, Инструкция по эксплуатации

Страница: 41 / 78

English
41
Overview of the components
1 CD compartment
2 CD tray lock (OPEN/LOCK)
3 VOLUME control (volume)
4 LCD display
5
IR sensor for the remote control
6 REPEAT button
7
button (Stop)
8 button (play/pause)
9 / buttons (search forward/backwards)
10 PROG button (Memory)
11 Memory card slot
12 AUX IN jack
13 USB connection
14 button (folder upward)
15 MUTE button
16 FOLDER- button (folder downward)
17 STANDBY/ON button (standby/power)
18 EQ button (Equalizer)
19 MODE function switch
20 BASS control
21 Nylon handle mounting
22 Telescopic antenna
A Speaker
Rear view (not shown)
POWER ON/OFF switch
DC IN 12 V Power supply connection
Battery compartment
Remote control
1 STANDBY button
2 FM button (radio)
3 AUX IN button
4 PROG button (Memory)
5 PRESET utton (radio memory)
6 ID3 button
7 EQ button
8
/ SKIP/TUNING UP button (search forward)
/ SKIP/TUNING DOWN button (search backwards)
9 STOP / FM MONO/ST button
10 /- (volume) button
11
PLAY/PAUSE button
12 RANDOM button (random playback)
13 REPEAT button
14 /- buttons (Album selection)
15 MUTE button
16 CD/USB/SD button
Installation/Introduction
• Read the manual thoroughly before operating the de -
vice!
• Select a suitable location for the device. Suitable loca -
tions are dry, even and anti-slip surfaces on which you
may operate the device easily.
• Make sure there is proper ventilation for the device!
• Remove, if necessary, the protection sheet from the
display.
WARNING:
Turning up the volume too high may damage your hearing.
Power supply
• Insert the grid plug into a properly installed three prong
socket with 230 V, 50 Hz. Connect the device with the
plug connector by inserting its plug into the IN 12 V jack
of the device.
• Make sure the grid voltage corresponds to the figures on
the rating plate.
CAUTION:
• The included AC adapter may only be used with this
device. Do not use it for other devices.
• Use only an AC adapter with 12 V ( ). A differ-
ent AC adapter may damage the unit.
• The mains plug shall remain readily operable.
• The direct plug-in adapter is used as the disconnect
device, the disconnect device shall remain readily
operable
NOTE:
• Disconnect from mains power supply during longer
periods of non-use.
• The preset time and station is lost as soon as the power
supply has been interrupted.
Battery Operation (Batteries not supplied)
• Open the lid of the battery compartment on the rear
side.
• Insert the 10 batteries type UM1/R20 1.5 V. Observe the
correct polarity (see bottom of battery compartment)!
• Close the battery compartment.
Should the device not be used for a long periods, remove
the batteries, to prevent any “leakage”.
NOTE:
• If a mains cable is connected, the batteries are auto -
matically switched off.
• The preset time station is lost as soon as you remove
the batteries.
b