AEG OL8000, Инструкции по эксплуатации и безопасности

Страница: 35 / 164

36 GB
J
Do not use the cables to carry the device or
pull it. Always disconnect the device by
pulling the plug, do not pull the cable.
J
Operate the device only when it is not dam-
aged.
J
Do not operate the device when it was
dropped or damaged otherwise.
J
The device shall not be dismantled, repaired
independently or modified (changed).
J
All repairs on the device have to be carried
out through a qualified electrician. There are
no exchangeable parts inside the device.
J
Before you finally delete errors from the error
memory of the OBD II diagnostic device
OL 8000, all errors on the vehicles should be
fixed.
J
Take care for a safe position when resting
the device. Route the connection cable in
such a way that it does not disturb the
check of the vehicle. Do not lead the cable
along sharp edges or corners and hot surfaces.
J
The OBD II diagnostic device OL 8000 is not
suitable for the permanent installation in a
vehicle. Do not operate the device while
driving.
J
Do not connect other cables to the device.
J
Carry out the check with the OBD II diag-
nostic device OL 8000 only in a safe environ-
ment. Keep away clothing, hair, limbs and
the OBD II diagnostic device OL 8000 away
from moveable or hot engine parts.
J
During the usage of the OBD II diagnostic
device OL 8000 the working area must be
well ventilated.
J
Comply with safety regulations when the
vehicle is jacked or is positioned on a lifting
platform or similar.
J
Do not use other measuring devices on the
vehicle during the use of the OBD II diag-
nostic device OL 8000.
J
Attention, high voltage in the area of the
ignition coils, distributor cap, ignition cable,
spark plugs and electrical components in the
vehicles.
J
Check if the vehicle is suitable for diagnosis.
Connect the OBD II diagnostic device
OL 8000 with the vehicle only when the
ignition is turned off.
J
The deletion of error codes does not rectify
the error on the vehicle. These error codes
can be displayed again, until the damage is
repaired by a garage. Let a specialised garage
repair the malfunction on the vehicle.
Start-up / Operation
Analyse error codes
The enclosed software CD covers most of the er-
ror codes displayed. You will receive information
on more recent and some special error codes
(mainly „B“, „C“ and „U“) either via internet
search engines (Search: „OBD 2“) or from your
specialised dealer
Security / Start-up / Operation