8
www.aeg.com
TIPS ON HOW TO GET THE BEST RESULTS
NOZZLE/ACCESSORY
USE FOR:
NOZZLE/ACCESSORY
USE FOR:
K. 3in1 accessory tool*
3 tools in 1:
1. Dusting tool for hard surfaces
(bookshelves, skirting boards etc).
2. Upholstery tool for textiles
(curtains, upholstery etc).
3. Crevice tool for narrow spaces
(behind radiators etc).
U. FlowMotion nozzle*
V. FlowMotion LED
nozzle*
Universal nozzle:
- For all floor types, secures best dust pick
up on both carpets and hard floors.
- Change nozzle setting with the pedal.
Icon will show recommended floor type.
- Front light helps to detect dust and
dirt in dark spaces (under furniture etc).
PureVision only
1
2
3
W. Turbo nozzle*
Carpet nozzle:
- Brushes and vacuums at the same
time (best pick up of hair, fibres
etc).
- Brush roller is driven by the airflow
of the vacuum cleaner.
- Not suitable for carpets with very
deep piles and long fringes, anti-
slip carpets like door mats or water
resistant carpets. Use universal
nozzle instead.
X. Mini Turbo nozzle*
Upholstery nozzle:
- Brushes and vacuums at the same time
(best pick up of hair, fibres etc).
- For textile furniture, car seats, mattresses
etc.
- Brush roller is driven by the airflow of the
vacuum cleaner.
- Not suitable for carpets with very deep
pile and long fringes as it can get stuck in
the rotating brush roll.
Y. ParkettoPro nozzle*
Hard floor nozzle:
- For gentle cleaning of hard floor
(parquet, wooden floor, tiles etc).
- Best dust pick up on hard floor
with crevice.
Z. FlexProPlus nozzle*
Hardfloor nozzle:
- For reach under/between furniture,
corners and other obstacles.
- Can easily turn 180 degrees for direct
access to narrow spaces.
AA. Long crevice nozzle*
Extra long tool:
- For areas hard to reach (top of
shelves etc).
- For narrow spaces (behind
radiators, under car seats etc).
Models with manual power regulation
– follow graphics on cleaner for optimal performance.
TROUBLESHOOTING
PROBLEM
SOLUTION
The vacuum cleaner does not start
• Check that the cable is connected to the mains.
• Check that the plug and cable are not damaged.
• Check for a blown fuse.
• Check if the battery indicator lamp in the remote control handle responds (certain models only).
The cleaner stops
The cleaner might be overheated: disconnect it from the mains; check if the nozzle, tube, hose or filters
are blocked. Let the cleaner cool down for 120 minutes before plugging it in again.
If the cleaner still does not work, contact an authorized AEG service centre.
Reduction of suction capacity versus
normal
• Check if the dust compartment is full or blocked.
• Check if the air channel and inlet or outlet connection is blocked and needs to be cleared.
• Check if the pre-motor filter is clogged and needs changing.
• Check if nozzle is blocked and needs to be cleared.
• Check if hose is blocked by squeezing it gently. However, be careful in case the obstruction has been
caused by glass or needles caught inside the hose.
Note: The warranty does not cover any damage to the hose caused by cleaning it.
Water has been sucked into the vacuum
cleaner
It will be necessary to replace the motor at an authorized AEG service centre.
Damage to the motor caused by the penetration of water is not covered by the warranty.
For any further problems, contact an authorized AEG service centre.
