AEG IR 4468 BT, Инструкция по эксплуатации, Страница: 15 / 23

15
1. : Mute button
2. : Power on / Standby button
3.
Button: Press to return to the main menu.
4. : Increase volume button
5. : Decrease volume button
6. Button: Press to go back to previous track
7. Button: Press to change to next track
8. Play / Pause button
9. MODE Button: Switch between audio sources.
10. : Cursor up button
11. : Cursor left button
12. : Cursor right button
13. : Cursor down button
14.
OK Button
15. 0~9 : Call up favorites / memory, Input letters and num-
bers
16. EQ Button
17. INFO Button
18. PRESET Button
19. : Sleep Button
20.
ALARM Button
21. TIMER Button
To remove the batteries from the remote, use your thumb
to pull out the battery compartment cover.
Replace them with a two AAA type batteries
CAUTION:
Risk of explosion if batteries are replaced by an incorrect
type.
Dispose of used batteries according to the instructions.
Symbols on the display
Connection is being established, device functioning
Wireless connection established
FM radio function selected
FM radio reception: Mono
FM radio reception: Stereo
Speaker muted
Alarm on
Internet radio station saved as favorite
Getting Started
The packaging box contains the following items:
-
IR 4468 BT Internet radio
- Remote control
- AC power cord
- 3.5 mm adaptor cable
- 3.5 mm to RCA-jack adaptor cable
- User manual
Get the network ready
• For Wireless LAN (WLAN) connection:
Check if the WLAN LINK / ACT light of the wireless
access point or router is illuminated. Consult its user
manual if there are any questions.
NOTE:
Wi-Fi allows data transfer over short distances within
20 meters without the need of cabling between the
devices. Any walls or ceilings may reduce the strength
of the Wi-Fi connectivity.
Therefore try to locate the IR 4468 BT and / or the
access point within the distance mentioned above,
and avoid any obstacles between two devices.
• Connect the power cord to the AC socket (14) on the
backside of the appliance.
• During the initial start of the appliance, the system will
ask you to set Language and Network Configuration.
• First screen: Select “ Yes ” to check for networks when
turning on the alliance.
• Second screen: Select “ Yes ” in the second screen to
establish the connection with the network.
• Select “ Yes (WPS )” (only for WPS routers). Then press
the WPS button on your router.
• Select “ No ” if you prefer to listen to a terrestrial station
or if you want to use the speaker with an external play-
back device.
• If selected ” Yes ”, the display starts scanning for wireless
networks and shortly afterwards a list of available wire-
less networks is shown.
• The number of bars in the wireless symbol in front of the
network name (SSID) shows the relative signal strength
of the network.
• The key symbol indicates that the network is protected
by password.
• If the device does not find any wireless networks, “ No
Wireless Networks Found ” appears on the display. If
necessary change your location and check your WLAN
router.