AEG GYB00416DT, Инструкция по установке и эксплуатации

Страница: 40 / 64

38 www.aeg.com
4.5 starting the boiler
step action
1 Connect the plug of the boiler (3) to the earthed AC wall socket.
CAUTION! Extension cables and multi-plug adapters are not permitted
between the electrical socket and boiling water storage heater
connection.
2 Press the ON/OFF button (5) for min. 0.5 seconds. The white LED
indicator (4) comes on when the boiler starts. Wait until the boiler is
heated. For the 4 litre boiler approximately 15 minutes are necessary to
heat. For the 8 litre boiler approximately 21 minutes are necessary to
heat.
3 Push and hold the button on the boiling water handle (11). Turn the
handle counterclockwise to open the valve. Keep the valve open until
the system is flushed with one boiler fill (4 or 8 litres).
4 Give all user manuals to the end user of the appliance. The appliance is
now fully installed and ready for daily use.
5.1 Important operation information
• Read and follow all instructions in the SAFETY INFORMATION section.
• Refer to the separate manuals supplied with the other components for other
relevant information.
• The amount of boiling water provided is limited by the size of your boiler. When
no boiling water is provided anymore, close the boiling water tap and wait until
the boiler is heated. For the 4 litre boiler approximately 15 minutes are necessary
to heat. For the 8 litre boiler approximately 21 minutes are necessary to heat.
5.
DAILY USE