AEG DVD-4514, Руководство по эксплуатации

Страница: 74 / 254

74
Changing the default settings
LPCM output
Here you can determine the scanning rate of the Audio signal. A
higher scanning rate generally results in a better Audio signal.
Dolby Digital Setup
Dual Mono
The Audio output is normally in stereo. Here you have the possibility
to choose Mono-output instead of Stereo-output.
„
STEREO: The Audio output is in Stereo (default).
„
L-MONO: The Audio output is in Mono. In this case the signal of
the "left" stereo channel is transmitted to all speakers.
„
R-MONO: The Audio output is in Mono. In this case the signal of
the "right" stereo channel is transmitted to all speakers.
„
Mix-Mono: The Audio output is in Mono. In this case the signal
of the "both" stereo channel is transmitted to all speakers.
Dynamic
The term "Dynamic" describes the ratio of quietest and loudest
sound. If the dynamic range is very large, you will experience very
quiet and very loud sounds.
This may cause replay problems. Let us assume that you are
watching a DVD in a relatively loud environment. You can now
increase the volume to be able to hear also the very quiet passages,
however with the disadvantage that loud passages will be
unacceptably loud.
In this case it would make sense to compress the dynamic range (i.e.
reduce) and increase the output volume at the same time.
„
FULL - 1/4: The dynamic range is compressed slightly (1/4) to
full (FULL).
„
OFF: The dynamic range is not compressed at all (default).
D I G I T AL A U D I O S E T U P P A G E
D I G I T AL O U TP U T
C D
D O L BY D I G I TA L
D T S
M P E G
L P C M O U TP U T 4 8 K
9 6 K
Fig. 34
D O L B Y D I G I T AL S E T U P
D U A L M O NO S T E R E O
D Y N AM I C L - MO N O
R - MO N O
M I X- M O N O
Fig. 35
NOTE:
These Audio settings can be made at any time by pressing the
Audio button on the remote control.
D O LB Y D I G I T A L S E TU P
D U A L M O N O
D Y N A M I C
F U L L
3 / 4
1 / 2
1 / 4
O F F
Fig. 36
Layout Clatronic.book Seite 74 Dienstag, 7. Februar 2006 3:31 15