13
Operation - Installation
5.
Cleaning, care and
maintenance
Clean the surfaces when cold with a soft cloth and ordi-
nary cleaning products.
note
Avoid abrasive or corrosive cleaning products.
6. troubleshooting
6.1
Fault table
Fault
Cause
remedy
The heated air
smells unpleasant.
This can be caused
by dust during com-
missioning.
The smell will dissipate
within a few minutes.
The appliance
does not heat up.
The MCB/fuse has
responded/blown.
Replace the fuse/reset the
MCB.
The appliance
heats continuously.
The appliance is sub-
ject to a continuous
draught.
Remedy the cause of the
draught.
The temperature set-
ting was changed.
Set the required room
temperature at the temper-
ature selector.
There is a fault with
the power supply.
Disconnect the appliance
from the power supply
for 10 minutes and then
switch it back on. If the
problem occurs regularly,
arrange for your power
supply utility to check the
power supply.
The 24 h automatic
function is not per-
formed.
There was a power
failure.
Set the 24 h automatic
function again.
The setting at the op-
erating mode selec-
tor was changed.
Set the 24 h automatic
function again.
The clocks have
changed to summer/
wintertime.
Set the 24 h automatic
function again.
The elements at
the very top and
bottom don't get as
warm as the rest of
the appliance.
The elements at the
top have not com-
pletely filled.
The heating medium ex
-
pands when it gets warm.
It takes a little longer for
these elements to heat up.
Dirty marks appear
on the wall around
the appliance.
Dirty marks are
caused by contam-
inated air from the
interior (candles, cig-
arette smoke, poor
ventilation etc.).
Remedy the cause of any
air contamination.
If you cannot remedy the fault, notify your qualified con
-
tractor. To facilitate and speed up your request, provide
the number from the type plate (000000-0000-000000).
The type plate is located underneath the appliance on
the right hand side.
instAllAtion
7.
Safety
Only a qualified contractor should carry out installation,
commissioning, maintenance and repair of the appliance.
7.1
General safety instructions
We guarantee trouble-free function and operational relia-
bility only if original accessories and spare parts intended
for the appliance are used.
7.2
Instructions, standards and regulations
note
Observe all applicable national and regional regula
-
tions and instructions.
8.
Appliance description
8.1
Standard delivery
◦ Wall mounting bracket with fixing materials
◦
2 bathrobe hooks
The appliance is delivered fully wired.
9.
Installation
9.1
Installation site
wArning electrocution
Install the appliance in such a way that control
equipment cannot be touched by a person in the
bath or shower.
!
Material losses
Observe the minimum clearances in chapter "Spec
-
ification".
!
Material losses
Fit the appliance to a vertical wall that is tempera
-
ture-resistant to at least 80 °C.
!
Material losses
Never install the appliance directly below a wall
socket.