AEG AR 4026 DVD, Инструкция по эксплуатации

Страница: 40 / 46

English
40
Fault Symptoms Cause Solution
The CD does not
play back after
being inserted
into the device.
The volume con-
trol is set too low.
Turn up the
volume.
The device has
not been correctly
connected.
Check the +12 V
and earth connec-
tion.
CD works intermit-
tently (dropouts).
The surface of the
road is uneven.
Wait until the
road becomes
smoother before
playing the CD.
The device is not
firmly installed.
Install the device
firmly. Ensure that
the rear attach-
ment is used if the
vehicle does not
have any suitable
retainer for the
rear section of the
device.
The CD is dama-
ged.
Try another CD.
If this works
correctly, the first
CD is probably
damaged.
The CD is dirty. Clean the CD.
The device
may have been
installed in the
vehicle at the
wrong angle.
Please note that
a maximum
inclination of 20°
degrees should
not be exceeded!
No function. The ignition is Turn the ignition
key to “ON” or
“ACC”.
switched off. Replace the fuse
by another 15 A
fuse.
Device cannot be
switched on or off
via the ignition.
Incorrect con-
nection (each
car manufacturer
wires the ISO
connection in the
vehicle differently).
Please contact
your car workshop
or a vehicle
specialist for con-
nection adapters
may specifically for
your model.
The device does
not work correctly
(EJECT, LOAD,
PLAY).
The microcom-
puter has been
interfered with by
electromagnetic
fields.
Remove the CD
and insert it again.
Switch the device
off and on again.
The device cannot
be operated, but
“hangs up”.
The control
processor of the
device may have
been blocked by
overvoltage or un-
dervoltage in the
vehicle electrical
system.
Press the RESET
button.
Fault Symptoms Cause Solution
No radio recep-
tion.
The antenna cable
is not connected.
Insert the antenna
cable firmly into
the antenna
socket of the
device.
Poor radio recep-
tion.
It is possible that
your vehicle has
a special antenna
(phantom-po-
wered antenna.)
Please contact
your car workshop
or a vehicle spe-
cialist. (For other
manufacturers
there are specific
phantom power
supply adapters
and voltage adap-
ters available.)
In automatic
search mode the
radio does not
stop at a transmit-
ting station.
The transmission
signals are too
weak.
Tune in to a radio
station manually.
DVD cannot be
played.
DVD not finalised. Use a finalised
DVD.
Audio or Video
interference from
video files which
are played back
via USB or memo-
ry card.
Data flow is
"sluggish“. (See
section "Opera-
ting Instructions“
on page 7 for a
detailed explana-
tion).
Pause play using
the

II button.
Wait a few se-
conds and re-start
playback.
Handling a CD/DVD
Cleaning the CD
Before playing a CD, wipe it off
with a clean, dust-free cleaning
cloth. Pull out the CD in the
direction of the arrow.
CAUTION:
do not use any solvents such as petrol or thinning agents.
commercially available cleaning substances or antistatic
sprays will damage the device.
Inserting the CD
If the CD is inserted with the
printed side facing downwards,
the device may be damaged.
Always insert the CD with the
label facing upwards.
CAUTION:
if there is already a cd in the cd slit, do not try to insert a
second cd. this may damage the device.
05_AR4026DVD_AEG_SK.indd 40 03.08.11 12:32