AEG 25658G-M, Инструкция по использованию, установке и обслуживанию

Страница: 13 / 28

13
INSTALLATION
10) INSTALLING THE HOT PLATE
WITH THE BATTERY
Check that the appliance is in a good condition
after having removed the outer packaging and
internal wrappings from around the various loose
parts. In case of doubt, do not use the appliance
and contact qualified personnel.
Never leave the packaging materials
(cardboard, bags, polystyrene foam, nails, etc.)
within children’s reach since they could become
potential sources of danger.
The measurements of the opening made in the top
of the modular cabinet and into which the hot plate
will be installed are indicated in either fig. 9/A and
9/B.
Always comply with the measurements given for
the hole into which the appliance will be recessed
(see fig.9/A – 9/B and 10).
The appliance belongs to class 3 and is
therefore subject to all the provisions
established by the provisions governing such
appliances.
11) FIXING THE HOT PLATE
The hot plate has a special seal which prevents
liquid from infiltrating into the cabinet. Strictly
comply with the following instructions in order to
correctly apply this seal:
- Detach the seals from their backing, checking
that the transparent protection still adheres to the
seal itself.
- Overturn the hot plate and correctly position seal
“E” (fig. 11) under the edge of the hot plate itself,
so that the outer side of the seal perfectly
matches the outer perimetral edge of the hot
plate. The ends of the strips must fit together
without overlapping.
- Unscrew the ignition cap “T” (see fig. 14) and fit a
1,5 V battery (not included in the appliance) with
the positive “+” polarity turn inside. Rescrew the
cap.
- Evenly and securely fix the seal to the hot plate,
pressing it in place with the fingers.
- Fix the hob with the proper brackets “S” and fit
the prominent part into the porthole “H” on the
bottom; turn the screw “F” until the bracket “S”
stick on the top (fig. 12).
FIG. 14