AEBI Meyer Base Line 240 Series, Оригинальное руководство пользователя

Страница: 13 / 36

13 13
Base Line Installation
1. Choose a location for the Controller (30) that is convenient for the driver. Make certain Controller (30) is grounded by attaching ground wire to a good vehicle ground.
2. Attach the eyelet end of the 96" (2.5m) red wire (34) to the positive terminal of the battery and route the plug end to the location of the speed control. DO NOT attach to Controller (30) at
this time.
3. Take the 264" (6.7m) red wire (33) and route the large rubber plug end to the rear of the truck, securely tying to vehicle frame. Be certain wire is clear of any sharp or moving objects or
the vehicle’s exhaust system.
4. CAUTION: Some vehicles are designed to operate with exhaust temperatures as high as 1800°F (982°C). This can easily damage any wires which are routed too closely or allowed to come
in contact with any portion of the exhaust system. Be certain all wires are securely installed away from the exhaust system.
5. Be certain the motor leads will not be strained when the plug is attached. Plug the 264" (6.7m) red wire (33) into the socket. Secure black wire from socket (31) to a good grounding point
on vehicle frame. Clean all rust or undercoating from this area.
6. Attach red wire from motor plug (32) to positive (+) terminal of motor. Tape this connection! Attach black wire to negative (-) terminal of motor. Push plug (32) into the socket (31).
7. Perform the motor run test as described in paragraphs 3 and 4 of the “Caution” above. If the motor operates 264" (6.7m) red wire (33) and 96" (2.5m) red wire (34) can be attached to
their respective terminals on the Controller (30).
8. Meyer Products assumes no responsibility for installations not made in accordance with these instructions.
SAFETY PRECAUTIONS SAFETY PRECAUTIONS
SEE PAGES 6-7 FOR DEFINITIONS
1 5/9/11/12 19
22/23/24/25/27