24
24
Spreader Maintenance
Maintenance requirements for the Spreader during the winter season are relatively simple. Periodically inspect for loose bolts and nuts. Inspect for improper ground, broken wires,
frayed or cracked wire insulation. Replace as necessary.
WARNING: Disconnect power to spreader before servicing.
CAUTION: Do not attempt to service control unit. It is a solid-state electronic device and has no user serviceable parts; any attempt to do so will void warranty.
CAUTION: The electric motor is sealed and should not be taken apart for any reason. Disassembly of the motor will void warranty.
CAUTION: When replacing parts use only Meyer Products approved parts or risk voiding warranty.
CAUTION: When fi lling Hopper, make certain there are no large objects contained in the material which could cause the Auger Spinner to bind and stop operation of the Spreader Motor.
It is recommended to check for free rotation of the Auger Spinner before operating the Spreader due to possible buildup of material between the Auger and neck of the Hopper.
•
Use dielectric grease on all electrical connections, before and after each season and whenever the plugs are disconnected. This will ensure long life for the contacts and prevent
corrosion.
•
Wash unit after each use to prevent material build-up and corrosion.
•
Periodically inspect the motor seal located around the shaft and look for cracks or splits. If seal is damaged or missing contact the manufacturer for a replacement.
•
At the end of the season thoroughly clean all parts and paint or oil all bare metal surfaces (except for hopper and spinner which are stainless steel and do not require painting).
Using a paste wax on the inside of the hopper will help material fl ow smoothly. OIL SHAFT AT MOTOR BASE TO PREVENT RUST DURING NON-USE.
•
Do not attempt to clear Auger or Spinner or to perform any other maintenance or repair work on this Spreader unless the ignition switch is in the “OFF” position and the Motor
Plug (28) is disconnected from the Socket Assembly (27).
•
Salt must be loose and free from lumps and must be kept dry.
•
Empty Hopper after each use and hose the Spreader off.
•
When the Spreader is no longer being used, remove it from the vehicle. Remove any rust or corrosion from the metal parts, then prime the paint. Store Spreader in a suitable
location and attach weather plug (32) to socket (28) to protect from corrosion.
SAFETY PRECAUTIONS
SAFETY PRECAUTIONS
SEE PAGES 6-7 FOR DEFINITIONS
1/2/3/4
5/6/7/8/9/11/12/15/16/17
19/20
22/23/24/25/27
Содержание Meyer Base Line 240 Series
