AdventistSat GEOSATpro DVR1000ci, Руководство по установке

Страница: 37 / 39

www.adventistsat.com Toll Free 866-552-6882
35
The satellite receiver features very sensitive Strength and
Quality meters to align the dish. Connect the LNBF output to the
satellite receiver SAT IN using the 25’ or 75’ coax cable.
Connect the satellite receiver
TV OUT
to the television set
4.
5.
When using a Lacuna, SatHawk, BirDog or SatBuddy digital
satellite location and identification meter, connect the LNBF to the
meter and use data for standard LNB type, KU, AMC4, Horizontal
and Vertical transponders. Peak for AMC4.
Antenna IN . Place the Output Selector
Switch on the back of the receiver to Channel
3 or 4 and select the same channel on the
television set.
Power
ON
the
Master Power
switch on
the rear of the receiver.
6.
Power the receiver in the Operate mode
by pressing the
Power
button on the remote
control.
Press the MENU button.
Press the
CH/DOWN
arrow to select
Installation
.
Press OK .
Enter password
0000
with the remote
numeric keypad.
7.
8.
9.
10.
11.
Press the CH/DOWN arrow to select Antenna Setup .
Select satellite
AMC4 KU
by pressing the
VOL/LEFT
or
VOL/RIGHT
arrow.
Press the CH/DOWN arrow to select the 2nd line. This line
selects the frequency that the receiver is tuning.
12.
13.
14.
The Signal Strength Level and Signal Quality is displayed in the
lower left corner of the screen.