AdventistSat GEOSATpro DVR1000ci, Руководство по установке

Страница: 26 / 39

©2006 Adventistsat.com
24
While you or an assistant observes the Signal Quality reading meter,
slowly make a small left or right movement of the dish. If necessary,
sweep the other direction until an indicator bar appears at any signal
quality of 20% or better. As the dish is directed at any of the 30+
satellites visible over North America, the signal strength reading
will rise and fall. Only when the dish is aimed at the correct satellite
will the Signal Quality reading increase above 10%
Note: Signal
Level is not important at this time.
If no Signal Quality is detected, increase or decrease the elevation
by one degree and sweep once again. The elevation may need to
be adjusted up to +/- 5 degrees depending on the accuracy of the
post leveling and mechanical tolerances. Move the dish very slowly
to allow the receiver to process the signal information and update
the strength displays. Sweep extremely slow as a movement of just
1/2 of a degree can result in a perfect or no signal. This process
may need to be repeated many times to precisely aim and peak the
quality of the signal. Signal Quality must be at least 90% + on this
channel.
This screen shot shows a receiver and LNBF that are
properly connected, but the dish is not aimed at the
proper satellite.
This screen shot shows a receiver and LNBF that
are properly connected and the dish is aimed at the
proper satellite.
Note: Setting the LNBF Rotation is extremely
important! If the LNBF Rotation is not set to the
approximate angle , the satellite signal might not be
found.