10
PixLite 16 User Manual V1.2
© 2015 Advatek Lighting Pty Ltd
Below is the RJ45 socket pin-
out for the DMX connectors when the “LOR” wiring is selected:
Figure 3
Below is the RJ45 socket pin-
out for the DMX connectors when the “ESTA” wiring is selected:
Figure 4
5.4
–
Hardware Test Pattern
The controller features a built-in test pattern to assist in troubleshooting during an installation. To
put the controller into this mode,
press and hold the ‘Factory IP’
button for 3 seconds (
after
the
controller is already running.) The controller will then enter the test pattern mode and will display
red, green, blue and white sequentially in a repeating pattern on all pixels on each of the 16 outputs.
Pressing the button while in this mode will then cycle through each of the four colors successively
(on all outputs simultaneously) before returning to the current pattern again.
To exit the test mode press and hold the
‘Factory IP’
button down again for 3 seconds and then
release.
