Advantech FWA-1320, Руководство пользователя

Страница: 72 / 90

FWA-1320 User Manual 62
3.5.1.2 USB DOM
You need:

a PH2 screw driver

a standard USB DOM
To remove a USB DOM proceed in the reverse of the installation procedure in section
3.3.1.2:
1. Remove the USB DOM mounting screw..
2. Extract the USB DOM by pulling the DOM upwards evenly. Be sure not to bend
any USB DOM connector pins.
3. Install a new SSD following the mounting instructions of the same section.
3.5.1.3 mSATA SSD
You need:

a PH1 screw driver

a standard mSATA SSD
To remove a mSATA SSD proceed in the reverse of the installation procedure in sec-
tion 3.3.1.3:
1. Remove the mSATA mounting screw. Please be sure to hold the screw as the
spring mechanism in the mSATA connector will flip the mSATA module upwards
once the screw is lose.
2. Extract the mSATA module
Install a new SSD following the mounting instructions of the same section.
3.5.2 CMOS Battery
You need:

A BR2032 battery
To replace the RTC’s battery located at B1, pull the spring clip securing the battery
forward with your finger tip. Please handle with care and do not bend the spring clip.
Then extract the battery vertically.
Figure 3.34 Unlocking the battery
Keeping the spring clip pulled towards you, insert the replacement battery.
Please make sure you insert the battery in correct polarity with the positive pole fac-
ing the front panel and the negative pole facing the CPU heatsink. Trying to insert the
Warning! There is the danger of explosion if the battery is replaced incorrectly.
Replace the battery only with the same or equivalent type specified
above.
Dispose of used batteries according to the manufacturer's instructions.