Advantech EBPC-5250, Руководство пользователя

Страница: 18 / 41

EBPC-5250 User Manual 8
Figure 2.3 Installing an SBC
2.4 Installing a PCI Card or PC/104 Module or Riser
Card
The EBPC-5250 can support a PC/104 module or a PCI card depending on the SBC
specification. To install the module, simply insert the module in the corresponding
slot. Alternatively, it also supports up to 2 PCI cards via the optional riser card. To
install the optional riser card, please proceed as follows:
1. Remove the riser card support on top of the power supply with the 2 screws on
the outside of the chassis.
2. Fasten the riser card onto the support with the 2 screws provided. Then insert
the riser card into the PCI slot of the SBC. (Figure 2.4)
3. When you install the add-on card, please remove the round plastic cap on the
chassis so the screwdriver can be inserted to the hole to loosen or fasten the
screw on the I/O bracket on the rear plate. (Figure 2.5)
4. Remove the rear I/O bracket and insert a half-size PCI card into the lower slot
on the riser card.
When inserting a PCI card into the upper slot, if the length
is too long, there may not be enough room for installing the slim-type opti-
cal disk drive.
5. Fasten the add-on card onto the chassis and then replace the round plastic cap.
Note! Use caution when installing a PCI card or PC/104 module, please note
the height limit. If users install the PCI card (through the optional riser
card) and the PC/104 module at the same time, it may cause a mechan-
ical obstacle if some components on the PCI card or PC/104 module are
too high.