Advantage Controls MicroTron O Series, Руководство пользователя, Страница: 4 / 16

4
II. Unpacking
The Advantage MicroTron™ pump has been shipped to you as a complete package, ready for installation.
If shipping carton shows any signs of damage, notify the shipping company immediately upon receipt.
Advantage Controls cannot be held responsible for damage from shipping. Unpack the carton and insure
that the following items are present:
1. Metering pump 4. Injection fitting
2. Suction, discharge and priming tubing 5. Instruction manual
3. Foot valve and weight
III. Safety Considerations
NOTE: All MicroTron™ pumps are primed with water before leaving the factory. If the solution to
be pumped is not compatible with water, disassemble the pump fluid end before use. After
disassembly, thoroughly dry the pump head, valves, and seals before pump is reassembled
and used.
A. Chemical Compatibility
MicroTron™ metering pumps are designed to work with most liquid chemicals depending upon your
pump’s liquid end materials of construction. A chemical resistance chart is available for determining
specific compatibility with a wide variety of chemicals. If you have further compatibility questions, contact
Advantage Controls’ service department at 1-800-743-7531.
B. Safety and Preparation
Always wear the proper protective clothing and gear when working around chemicals and chemical
metering pumps. Safety glasses, gloves, and aprons are critical in preventing accidental exposure
to dangerous chemicals. Liquids under pressure can present a special hazard when a line or seal is
punctured resulting in the spraying of chemical many yards away. If a chemical spillage occurs, consult
the Material Safety Data Sheet (MSDS) for specific instructions regarding the chemical being used.
IV. Installation
A. Location
Select a mounting location convenient to the chemical supply and power for the pump. Do not install the
pump in a location where the ambient temperature exceeds 120 degrees F (50
o
C). Higher temperatures
will affect the output as well as the useful life of the pump. While the MicroTron™ pump is suitable for
most outdoor installations, do not use the standard poly tubing in direct sunlight. If you must mount pump
in direct sunlight or under bright fluorescent lights, consult your distributor or the factory. Accessory
item R00225 (plastic mounting bracket) is recommended for a secure installation.
B. Electrical
1. Standard MicroTron™ pumps have a voltage regulated internal power supply capable of operating
in the range of approximately 95 to 135 VAC. Use a supply voltage of 100 to 120 VAC for best
results. The 3-wire grounded plug must be used in a 3-wire wall plug.
CAUTION: Never remove ground wire from plug!
2. With a 220 volt option, the MicroTron™ pump has a voltage regulated internal power supply capable
of operating in the range of approximately 195 to 260 VAC. Use a supply voltage of 210 to 250
VAC for best results.