ADVANTAGE AIR MyAir, Руководство по установке

Страница: 13 / 23

Installation Guide V1.2
11
11 - TOSHIBA (CB7 TO) SETUP
CB7 TO setup steps are as follows:
1. Connect the Toshiba wired remote to the indoor unit in the roof space.
2. Power up the air conditioner & run the unit to test correct operation of indoor &
outdoor unit.
3. Using the Toshiba wired remote change the fi eld settings (DN code) for use
with either the Return Air Sensor or a MyZone Sensor (if supplied)
How to set Toshiba fi eld settings:
a. Push the MENU button to display the menu screen.
b. Push & hold the MENU + DOWN buttons at the same time for 4 seconds to
open the fi eld settings menu.
c. Use the DOWN arrow to select option 5, DN CODES
d. Press F2 then use UP / DOWN arrow to navigate to the required DN code
e. Press F2 to move right & highlight DATA value
f. Use UP/DOWN arrow to set required value
g. Use the MENU button to “
fi x” (store) the setting & press F1 to “con fi rm”
h. Press the RETURN button to go back to the fi eld settings menu, you will see
an hour glass for approx. 30 seconds.
i. Press RETURN twice more to go back to main screen
j. Repeat all the steps for each required setting
4. Power off the Toshiba air conditioner & remove Toshiba wired remote control
from system.
5. Connect the supplied cable from the CB to the indoor unit. Wire the cable cores
to the terminals as shown below:
CABLE CORE COLOUR INDOOR UNIT TERMINAL
RED A
BLACK B
6. Go to Section 15 SYSTEM CONFIGURATION to complete install
DN Code Value
Return Air Sensor
32 0000
MyZone Sensor
05 0009
DN Code Value
32 0001
05 0009