AdvanceTec AdvanceMobile AT3550A, Инструкция по установке и эксплуатации

Страница: 8 / 24

8
4. Cut the black lead to the desired length.
5. If the connection is being made under the dash or in the vehicle cabin,
connect the black lead directly to the chassis of the vehicle.
6. If the connection is being made in the engine compartment, connect the
in-line fuse holder between the black lead of the power cable and the desired
chassis connection point.
Note!
Do not connect the black lead to the negative (-) battery terminal.
The AdvanceMobile™ could be damaged if there were a malfunction in the
vehicle’s electrical system.
7. Cut the red lead to the desired length. This lead will be connected such
that it has positive supply voltage at all times, even when the vehicle is
turned off.
8. If the connection is being made under the dash or in the vehicle cabin,
connect the red lead to a positive supply voltage point.
9. If the connection is being made in the engine compartment or directly to
the battery, connect the in-line fuse holder between the red
lead of the power cable and the desired positive voltage connection point.
10. Route and connect the green lead to a convenient ignition switch supply
point in the vehicle.
Note!
An ignition switch accessory terminal can be verified by measuring
the terminal while operating the vehicle’s key switch. With the ignition key in
the “accessory ON” position, the terminal voltage should measure the
vehicle’s battery voltage. With the switch in the “OFF” position, it should
measure near zero
Stereo Mute
If the vehicle’s stereo system supports an external muting feature, route and
connects the orange wire to the car stereo system. Otherwise, the orange
wire may be left unconnected and cut off or tied out of the way.
Note!
The Car Kit supports an “Entertainment Mute” function when
connected to a car stereo system that provides for external muting. This
function is compatible with systems that mute the audio output when the
control line is connected to ground
E. Mount the Vehicular Antenna & GPS Antenna
1. Screw the antenna to the external magnetic (Mag) mount antenna base.
2. Mount the Mag Mount antenna or other external vehicular antenna (to be
purchased separately if the supplied Mag Mount Antenna does not fit your
purposes).
For best performance use a low-loss coaxial cable with the highest gain
antenna.