AdvanceTec AdvanceMobile AT3550A, Инструкция по установке и эксплуатации

Страница: 12 / 24

12
2. DO NOT mount the junction box at this stage. Connect the PTT,
Microphone, Speaker, Power cable and to their corresponding connections
on the Junction Box as indicated in Diagram below.
Mic. Speaker PTT Optional Optional Power
Control Module Palm Mic/.
Handset w/Cradle
Diagram 8
3. Connect the coaxial antenna cable to the corresponding connector on the
opposite side of the Junction Box.
4. After connecting the power cable's connector to the Junction Box,
cut in half the red wire attached to the fuse housing supplied. Cut the long
red power lead to the desired length and connect (crimp) it to the one end of
the wire to the fuse housing.
5. Connect the other end of the wire from the red fuse housing to the positive
(+) side of the ignition. The fuse housing can be secured in place by using a
plastic tie or screw through the hole in the fuse's plastic housing
System Registration and Programming
1. Once the AdvanceMobile™ is powered and the SIM is inserted, it will begin
the registration process onto the iDEN system. The initial registration onto
the iDEN system can take up to 3 minutes.
2. Once the AdvanceMobile™ has successfully registered onto the iDEN
system, 5 short pulses will be heard through the speaker.
3. After registration, the Private ID or Group ID with which the
AdvanceMobile™ will communicate must be loaded into the
AdvanceMobile™
4. To program the Private ID or Group ID, initiate a PTT call to the
AdvanceMobile™ from the phone with the Private ID or a phone that is part of
a Group ID with which you want the AdvanceMobile™ to communicate. Keep
the PTT button pressed
5. When the incoming PTT call is heard on the AdvanceMobile™ speaker,
with the PTT button still pressed, press in the programming button next to
the SIM flap by using a pen refill or similar devise.