ENGLISH
INSTRUCTIONS FOR USE
24
9096910000(2)2010-03
Ad
fi
nity™ 20D - X20D - X20C - X24D
VACUUM SYSTEM MOTOR FILTER CLEANING
Drive the machine on a level
fl
oor.
1.
Turn the ignition key (80) to “0” position.
2.
Open the recovery water tank.
3.
If necessary, drain the water from the tank in order to make the
fi
lter visible.
4.
Check that the pre-
fi
lter is clean. If necessary clean it with water and compressed air, then install it.
5.
Carry out steps 1, 2 and 3 in the reverse order.
6.
SOLUTION FILTER CLEANING
(For Ad
fi
nity™ 20D)
Drive the machine on a level
fl
oor.
1.
Turn the ignition key (80) to “0” position.
2.
Close the solution tap (A, Fig. 8) under the machine, behind the right rear wheel. The tap (A) is closed when it is on the
3.
position (B) and it is open when it is on the position (C).
Remove the transparent cover (D), then remove the
fi
lter strainer (E). Clean and install them on the support (F).
4.
NOTE
The
fi
lter strainer (E) must be correctly positioned on the housing (G) of the support (F).
Open the tap (A).
5.
E
G
B
A
D
C
F
E
S311322
Figure 8
9096910000(2)2010-03.indb 24
9096910000(2)2010-03.indb 24
16/03/2010 13.53.28
16/03/2010 13.53.28
