ADTRAN 1200212L1, Руководство пользователя

Страница: 45 / 172

Chapter 3. Operation
61200212L1-1 DSU IQ User Manual 3-5
VT 100 Terminal Connection and Operation
To control the DSU IQ using a VT 100 terminal, perform the
following steps:
Step Action
1 Set the DSU IQ baud rate to match the terminal through
the front panel (maximum rate is 38.4k). Select
C
ONFIG
,
then C
ONTROL
P
ORT
.
2 Using the ADTRAN provided VT 100 terminal adapter,
connect the COM port of a VT 100 compatible terminal or
equivalent to the eight-pin modular jack labeled Control
on the rear of the DSU IQ. This connection is used for both
local and remote configuration.
3 Open the connection and press
Enter
repeatedly until the
L
OGIN
M
ENU
appears (Figure 3-3 on page 3- 6).
4 Select L
OCAL
L
OGIN
to configure the DSU IQ unit connect-
ed to the terminal.
5 Select R
EMOTE
L
OGIN
to configure a remotely located DSU
IQ unit.
6 For remote applications, enter the DLCI (data link connec-
tion identifier) number of the remote unit by pressing
1 ,
Enter
, the DLCI number, and
Enter
again.
7 Select B
EGIN
R
EMOTE
S
ESSION
by pressing 2 and
Enter
.
8 Enter the password. The factory default password is adt-
ran. The main menu will appear (Figure 3-4 on page 3- 6).
9 Make selections by entering the number corresponding to
the chosen parameter. Press
ESC
to return to the previous
screen.
When entering the DLCI for a remote application, enter the DLCI associ-
ated with the local unit that you are logged onto ( not the far end DLCI).
If the wrong DLCI is entered or a network problem exists, the screen freez-
es at the
P
RESS ANY KEY TO CONTINUE
prompt. Press
CNTL + L
twice to
return the unit to the Login screen.